PhaseLabs

Add heat and watch what happens. The temperature climbs, then stops at melting and boiling while the particles pull apart. Or switch to Forces and pull the molecules apart yourself.

Track 1 · General Chemistry 1 · the lab for PhaseWorks · part of ChemLabs

Temperature
State
Doing now

Heating curve

Heat needed for each step

What PhaseLabs shows

A heating curve plots temperature against the heat added to a sample. In this free simulation, 50 g of ice at −30 °C is heated step by step. While the sample is a single phase, the heat raises the temperature: q = m × c × ΔT, with c = 2.09 J/(g·°C) for ice, 4.18 J/(g·°C) for liquid water and 2.01 J/(g·°C) for steam. At 0 °C and 100 °C the curve goes flat, because the heat is breaking attractions between molecules instead of speeding them up: q = m × ΔH, with ΔHfus = 334 J/g (6.01 kJ/mol) and ΔHvap = 2260 J/g (40.7 kJ/mol). Drag the heat slider, change the mass, and watch the particles, the plateaus and the table of heats follow.

The Forces mode shows why the plateaus sit where they do. Molecules attract each other through London dispersion forces (every molecule, stronger for bigger electron clouds), dipole–dipole forces (polar molecules) and hydrogen bonds (H bonded to F, O or N, the strongest of the three). Drag a molecule away from its neighbours and watch the band stretch and the energy meter climb. Compare ten molecules, from N2 to H2O: the stronger the forces, the more energy it takes to pull one free and the higher the boiling point. Then pull a water molecule off an ion to meet ion–dipole forces, stronger still: a small, highly charged ion like Mg2+ holds water far tighter than a large K+.

© 2026 Prof. Rami El Oweini. All rights reserved.